|
Tytuł: huawei E176 - przyłaczamy do Linuksa Wiadomość wysłana przez: markcomp Maja 22, 2009, 06:29:37 huawei E176 - przyłaczamy do Linuksa
http://blog.tech-pro.net/entry/38/Linux_and_the_Huawei_E169G http://www.murga-linux.com/puppy/viewtopic.php?t=36882 http://wiki.debian.org/Huawei/E220 http://ubuntuforums.org/showthread.php?p=7249497 Tytuł: Odp: huawei E176 - przyłaczamy do Linuksa Wiadomość wysłana przez: markcomp Maja 25, 2009, 10:10:22 Cytuj I have a Huawei E169 working with puppy-4.1.2. I just opened the file /etc/rc.d/rc.local in a text editor, added the following line: Code: modprobe usbserial vendor=0x12d1 product=0x1001 Then I used pupdial to probe for the modem. I think I then had problems with wvdial giving a very low connect speed, so I needed to open /etc/wvdial.conf in a text editor, and edit it to have: Code: [Dialer Defaults] Modem = /dev/ttyUSB0 Baud = 460800 Init1 = ATZ Init2 = ATQ0 V1 E1 S0=0 &C1 &D2 +FCLASS=0 Carrier Check = no Dial Command = ATDT Phone = *99# Username = ppp Password = ppp Auto Reconnect = yes [Dialer isp2] Phone = MY2ISPPHONENUM Username = MY2USERNAME Password = MY2PASSWORD Auto Reconnect = yes I then rebooted, and the device is detected OK. Then ran pupdial & connected fine. I used an optus prepaid service, just recently on a train from Sydney to Melbourne, and while there were plenty of places with no signal, it switched from HSPA to GSM seamlessly. Edit: Instead of relying on memory, I've added my current wvdial.conf, which I'm using to post this using an E169. |