rozważania o CNC

Marzec 28, 2024, 10:12:20
Witamy, Gość. Zaloguj się lub zarejestruj.

Zaloguj się podając nazwę użytkownika, hasło i długość sesji
Strony: [1]   Do dołu
  Drukuj  
Autor Wątek: zawsze ładowany gcode  (Przeczytany 8281 razy)
markcomp
Administrator
*****
Offline Offline

Wiadomości: 14870



WWW
« : Październik 29, 2014, 11:26:52 »

zawsze ładowany gcode

Cytat: dokumentacja linuxCNC
Defaults

When LinuxCNC first starts up many G and M codes are loaded by default. The current active G and M codes can be viewed on the MDI tab in the Active G-Codes: window in the AXIS interface. These G and M codes define the behavior of LinuxCNC and it is important that you understand what each one does before running LinuxCNC. The defaults can be changed when running a G-Code file and left in a different state than when you started your LinuxCNC session. The best practice is to set the defaults needed for the job in the preamble of your G-Code file and not assume that the defaults have not changed.

po naszemu będzie... w skrócie...

Po starcie LinuxCNC na już załadaowane pewne G i M kody, można zobaczyć jakie na zakładce MDI - w okienku "Aktywne G-kody". Najlepiej jednak potrzebne ustawienia zawrzeć na początku swojego pliku z GCodem...


« Ostatnia zmiana: Październik 29, 2014, 12:17:58 wysłane przez markcomp » Zapisane

MARKcomp77

http://oferta.forum-cnc.pl/
Sterowniki.Silniki

Strony: [1]   Do góry
  Drukuj  
 
Skocz do:  


Powered by SMF 1.1.4 | SMF © 2006-2007, Simple Machines LLC
Manuscript design by Bloc Strona wygenerowana w 0.046 sekund z 19 zapytaniami.